On updating

This pin must be pulled low before power is applied, or at least before letting the RN4871 come out of reset, because it is only sampled at the time. The Update Tool must also have control of the serial lines, RX and TX.In my application circuit, RX and TX go directly to TX and RX on my PIC.

on updating-40on updating-28on updating-9

Thanks to traversjames for your suggestions on going to page 43 of the PICtail manual.First of all, the condition of my RN4871 had become totally non-responsive.Give a go for some of these: "Official" TT tips: https://en.discussions.tomtom.com/go-800-1000-2000-series-via-series-start-20-and-60-series-mydrive-19/faq-mydrive-connect-troubleshooting-tips-990570 If these didn't help, then try some of these: *Always make sure that you are logged in with the correct account.One device, one account* *** for Windows 10 users *** If you have just updated recently, you might run into trouble with TT (and other devices too).But many of those challenges have roots in structural, political, and economic problems Puerto Rico has suffered from long before Maria made landfall.

Today I successfully brought a RN4871 back from the bricked state to normal functionality, so I thought I would summarize the procedure with some details I observed along the way.

Thanks so much for sharing your experience The tool you used is actually normally used to update firmware and it "cleans up" the firmware inside the module.

Can you please check what is the MAC address of your module by connecting to it ?

*** TT CS official reply that worked for many with W10 issue *** Close My Drive Connect completely: If your navigation device is connected to the computer, disconnect it. Delete the My Drive Connect folder from: C:\Program Files (x86) (if still present) Delete the Tom Tom folder from: C:\Users\[username]\App Data\Local\ (USERNAME - It is the user name which you use to login to Windows ) Delete the Tom Tom folder from: C:\Users\[username]\App Data\Roaming\ Delete every file and folder from: C:\Windows\Temp\ (in case some files can't be removed, reboot the PC and retry) Restart your computer.

Click the My Drive Connect icon ( or ) in the Windows notification area or Apple menu bar and then select Quit Uninstall My Drive: Click on the Start button and go to All Programs › Tom Tom › Uninstall Tom Tom My Drive Alternatively you can use Add or Remove Programs in the Contol Panel to remove Tom Tom My Drive Connect. Re download a new installer from (I recommend you to use the Google Chrome while downloading the installer) Now install My Drive Connect with the newly downloaded installer.

I downloaded RN487x Firmware Update Tool -Is and RN487x Firmware v1.18.3 - Apr14from Microchip. Jumper telling the PIC to "go passive" was in place.2. RX, TX, Vcc, GND taps for my interface circuit were connected. Then I clicked on Disconnect and powered down the application circuit.